Bang-olufsen BeoLink Wireless 1 - User Guide Manuale Utente

BeoLink Wireless 1 Guide

Wireless 1 – Transmitter/receiver … Wireless 1 must be set up as either transmitter or receiver. Before fastening the transmitter and receiver to the

Wireless 1 – wall mount Wireless 1 can be fastened to a wall (or ceiling) with one of the two enclosed brackets – in either a horisontal or a vertical

>> Set up BeoLink Wireless 1 Connections – Master LinkIn the main room: Connect the transmitter to the Master Link socket on the main system. Th

Connections – Power LinkIn the main room: Connect the transmitter to the Master Link socket on the main system. Then connect both the main system and

‘IR-eye’ – cable connections The small circular ‘IR-eye’ is available from a Bang & Olufsen retailer. An ‘IR-eye’ must be used in each link room w

‘IR-eye’ – wall mount If the ‘IR-eye’ is placed next to a door and at a suitable height, you can easily switch on or off by close-up operation when en

Option settings When you have made all the connections as described on the previous pages or in the Guides enclosed with your link room products, you

Use a Beo4 remote control to set the Option. The entire system must be switched to standby: > While holding down the • button, press LIST. > Let

The European Parliament and the Council of the European Union have issued the Waste Electrical and Electronic Equipment Directive. The purpose of the

This product is in conformity with the provisions of the Directives 1999/5/EC and 2006/95/EC. This product may be used in member states of the EEU and

WARNING: To reduce the risk of fire or electric shock, do not expose this appliance to rain or moisture. Do not expose this equipment to dripping or

3509535 0703www.bang-olufsen.com

Introduction, 4 This chapter provides you with an overview of the Wireless 1 system in the main room and the link room and describes the Master Link a

Introduction Master Link setup If your link room product is either an audio or a video system, it must be connected to BeoLink Wireless 1 with a Maste

Power Link setup If your link room product is a pair of active speakers, they must be connected to BeoLink Wireless 1 with Power Link cables. This set

Close-up operation This page concerns only a Power Link setup with an ‘IR-eye’. For information about close-up operation of link room products set up

Beo4 remote control This page concerns only a Power Link setup with an ‘IR-eye’. For information about Beo4 remote control operation of link room prod

This page concerns only a Power Link setup with an ‘IR-eye’. For information about sound adjustments of link room products in Master Link setups, refe

Set up BeoLink Wireless 1 On the next pages is explained how to install a set of BeoLink Wireless 1 – both in the main room and in a link room. We re